Non-stabilized Argon Oxygen Decarburisation (AODNS) slag in powdered form was examined for its carbon dioxide sequestration capacity and for its potential utilisation in the fabrication of high value building materials. The curing of the sample was carried out in two accelerated carbonation environments: (i) in a carbonation chamber, maintained at atmospheric pressure, 22 degrees C, 5 vol.% CO2 and 80% RH; and (ii) in a carbonation reactor, where the CO2 partial pressure (pCO(2)) and temperature could be further increased. In the carbonation chamber, an average compressive strength of over 20 MPa, on a 64 cm(3) cubic specimen, was obtained after one week of curing, which is sufficient for many construction applications. Further carbonation resulted in a linear increase of strength up similar to 30 MPa after three weeks. The CO2 uptake followed a similar trend, reaching a maximum of 4.3 wt.%. In the reactor, the compressive strength improved with an increase in pCO(2) up to 8 bar, temperature up to 80 degrees C, and duration up to 15 h where the maximum CO2 uptake was 8.1 wt.%. The reduction in porosity in the carbonated specimens was approximately in line with the strength gain in the samples. Phase analysis by X-ray powder diffraction and inspection by scanning electron microscopy showed the precipitation of calcite and formation of significant amounts of amorphous material after carbonation. Infrared spectroscopy also pointed to the presence of aragonite and vaterite. In the carbonation chamber, the calcite morphology was uniform throughout the specimen. In the reactor, however, the calcite crystals near the outer edges of the cubes had different morphology than those near the core. Carbonation of the slag resulted in the reduction of basicity by up to one pH unit, and contributed to controlling the leaching of several heavy metals and metalloids. (C) 2014 Elsevier B.V. All rights reserved.