A new Additive-Manufacturing (AM) or 3D printing concept is proposed to improve the printing resolution for metal additive manufacturing in the frame of the SFA-AM project, Powder Focusing for Beam-Induced Laser 3D Printing. The project aims to transport small powder particles (largest diameter < 10 um) at a high throughput to a spot smaller than 20 µm. To realize the objective, a metal ion included liquid is suggested as a source medium similar to the inkjet process, and the droplet is employed as a container for the metal ion transport. The key challenges of achieving this goal are 1) droplet size control and 2) efficient microwave heating that can dry the liquid portion of the dynamic droplet at a high-speed (3 m/s). The most demanding part is the development of a miniaturized, very concentrated field density microwave resonator where the droplet is passing through. This follows from the extremely short interaction time between the microwave and the ejected droplets (research: 0.5 ms) which results from the requirement for a small system size for its integration. The primary medium examined for the experiment is water due to 1) a high dielectric loss proportional to the drying efficiency and 2) avoiding explosion risks at the laser sintering stage compared to organic solutions. Various droplet generation conditions were investigated to determine the optimum conditions for the custom droplet generator, in particular, two key parameters were focused on: frequency and flow rate. The droplets obtained were analyzed with respect to size, gap distance, and linearity affecting the uniformity of the AM process. Moreover, Navier-Stokes-based fluid dynamics simulations enabled understanding of droplets behaviors, especially break-up formation. Eventually, the optimal condition for producing the smallest droplets with a diameter of 100 µm is determined to be 15 kHz and 0.5 ml/min. Such droplets loaded with metallic particles could result in smaller than 20 um of remaining metal powders aggregate after the drying process. A new TEM (Transverse ElectroMagnetic) resonator has been developed for drying and sensing applications. A full-wave electromagnetic simulation software, CST Microwave Studio, supported the working mode of the device. Firstly, it is used for the dielectric characterizations of different water-ethanol mixtures contained in a micro capillary. The sensing relies on electric field perturbation due to the inserted sample, and is measured based on the change of both resonance frequency and Q-factor. These sample-dependent variations were analyzed to estimate the complex permittivity using different methods such as the Perturbation Method (PM), Least-Square Model (LSM), and Log-Linear Model (LLM). This work demonstrates that the proposed microwave module is capable of sensing nano-liter volume ranges even though the samples only partially influence the sensing area (error < 13 % in permittivity). In microwave heating, the developed resonator achieved a temperature increase of 28 K in the microwave exposal time of 0.5 ms when the microwave power of 45 W was applied. Finally, numerical models have been proposed to estimate the maximum temperature of the initial droplet before cooling starts attributable to heat and mass transfer. This model well corresponds to the microwave electromagnetic simulation resulting in similar temperature deviations. It helps to determine the net heating efficiency of the microwave device.