A Wearable System Of Micromachined Piezoelectric Cantilevers Coupled To A Rotational Oscillating Mass For On-Body Energy Harvesting

In this paper, we present a compact, wearable piezoelectric on-body harvesting system that uses a small eccentric mass from a common watch movement to mechanically deflect a set of micromachined piezoelectric cantilevers when excited by the low frequency movements of the human body. The piezoelectric cantilevers are directly coupled to the rotating mass via a set of pins located near its rotational center. The energy produced by each pluck of a single cantilever is 545 nJ, corresponding to a maximum output power of 11 mu W for continuous plucking; however, accounting for the periodic rest of typical human motion, the average output power over a full day cycle will be considerably less.

Published in:
27th International Conference On Micro Electro Mechanical Systems (MEMS), 370-373
Presented at:
27th IEEE International Conference on Micro Electro Mechanical Systems (MEMS), San Francisco, USA, January 26-30, 2014
New York, IEEE

 Record created 2015-05-29, last modified 2020-07-29

Rate this document:

Rate this document:
(Not yet reviewed)