Test Results of a 100 kA NbTi CICC

For the secondary winding of the flux pump (superconducting transformer) of the EDIPO test facility at CRPP Villigen, a NbTi cable-in-conduit conductor (CICC) was designed at CRPP and procured at the industry. From a left section of the CICC a SULTAN sample, nicknamed TRASEK, has been assembled and tested. In the conductor design, high Cu:non-Cu ratio in the strand (no copper segregation), low void fraction and SnAg5 coating of the strand surface are selected to allow smooth current redistribution and enhance the take-off voltage. The DC tests are carried out before and after solder filling the sample termination and current sharing is observed up to 80 kA. Eventually, the DC conductor performance is limited by the self field of the sample in the U-bend region. In normal operation, the secondary coil of the transformer is not exposed to significant magnetic field sweeps. The AC loss is expected to be large according to the design choices (tin coating, low void fraction). The AC loss characterization in SULTAN includes over 400 load cycles. The pressure drop vs. mass flow rate is measured in SULTAN to complement the data base for friction factor of CICC's.

Published in:
Ieee Transactions On Applied Superconductivity, 22, 3
Presented at:
22nd International Conference on Magnet Technology (MT)
Piscataway, Ieee-Inst Electrical Electronics Engineers Inc

 Record created 2013-02-27, last modified 2019-08-12

Rate this document:

Rate this document:
(Not yet reviewed)