Loading...
journal article
Selection and design of brazing fillers for metal-ceramic joints
Three different approaches for metal to ceramic brazing are compared using the example of Si3N4/TiN-steel joints: the use of an active filler metal (single layer brazing system), the metallisation of the ceramic and brazing with a non active filler (two-layer brazing system), the use of a composite brazing filler system (three layer brazing system). Different aspects are analysed: the development of the joint's microstructure in the as-brazed state, the thermally induced residual stresses and the resulting bend strength of the joint's strength.
Use this identifier to reference this record
Type
journal article
Authors
Publication date
2007
Published in
Volume
539-543
Start page
4008
End page
4012
Peer reviewed
NON-REVIEWED
EPFL units
Available on Infoscience
May 26, 2010