Inkjet printed colorimetric ammonia sensor on plastic foil for low-cost and low-power devices

A polymeric-based colorimetric gas sensor with its associated electronics targeting ammonia detectionat low-cost and low-power is presented. The gas sensitive layer was inkjet printed on a plastic foil used as an optical waveguide. The planarconfiguration of the sensor makes it compatible with large scale fabrication techniques, such as rollto-roll processes. Its power consumption and noise level were measured. The sensor exhibited a good sensitivity to ammonia with a theoretical limit of detection of 104 ppb in a constant operation mode. The power consumption was reduced to the submW range when operating in pulsed mode. It foresees applications in the field of wirelesssystems, for environmental and safety monitoring.

Published in:
Proceedings of the MEMS 2010, 1, 883-886
Presented at:
MEMS 2010, Hong Kong, January 24-28, 2010
Ieee Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa

Note: The status of this file is: Anyone

 Record created 2010-02-03, last modified 2020-10-24

Download fulltext

Rate this document:

Rate this document:
(Not yet reviewed)