Ageing of anode-supported solid oxide fuel cell stacks including thermal cycling, and expansion behaviour of MgO–NiO anodes

This paper reports on medium term tests of anode-supported five-cell short stacks, as well as on some separate anode development. Two stacks were operated under steady-state conditions: one with unprotected metal interconnects, H2 fuel and 0.35Acm−2 (40% fuel utilisation) polarisation current showed an average cell voltage degradation of 56mV per 1000 h for 2750 h; one with coated metal interconnects, synthetic reformate fuel and 0.5Acm−2 (60% fuel utilisation) polarisation current showed an averaged cell voltage degradation slope of 6.6mV per 1000 h for 800 h before a power cut prematurely interrupted the test. A third stackwas subjected to 13 complete thermal cycles over 1000 h, average cell voltage degradation was evaluated to −2mV per cycle for operation at 0.3Acm−2, open circuit voltage (OCV) remained stable, whereas area specific resistance (ASR) increase amounted on average to 0.008 cm2 per cycle. To improve anode reoxidation tolerance, MgO addition was considered. (Mg, Ni)O solid solutions were synthesized from MgO and NiO powders at 1500 ◦C for 2 h in air. Samples were reduced at 1000 ◦C in 4 vol% H2 in N2, and their expansion behaviour was observed. XRD and SEM/EDX analysis suggested that the expansion was caused by the segregation of Ni particles between (Mg, Ni)O grains.

Published in:
Journal of Power Sources, 182, 2, 389-399
Invited paper doi:10.1016/j.powersour.2008.03.006

Note: The status of this file is: EPFL only

 Record created 2009-01-08, last modified 2020-10-25

Download fulltext

Rate this document:

Rate this document:
(Not yet reviewed)