Optimisation of a Thick-Film 10...400 N Force Sensor
The ring-on-ring bending principle allows the fabrication of simple, low-cost thick-film piezoresistive sensors for compressive forces in the 10 to 400 N range. However some imperfections are encountered in its basic embodiment, such as relatively high force-signal hysteresis and nonrepeatability (up to ca. 5%). These shortcoming were studied in this work, and major improvements achieved. Hysteresis was found to be mainly due to friction at the outer support ring, and considerably reduced by inserting a compliant silicone glue ring. The same glue ring was used to permanently bond the sensor to a rigid base, thereby giving well-defined and constant boundary conditions and also considerably improving the repeatability of the sensitivity. Overall, hysteresis and repeatability error were reduced down to a level of ca. 1%.
2008 Maeder - MR - optimisation CentoNewton v2 - postprint.pdf
Postprint
openaccess
846.92 KB
Adobe PDF
3c0df35611a42bc2029ba9d33dd750a8
2007 Maeder IMAPS PL Krasiczyn optimisation capteur force CentoNewton P.pdf
openaccess
1.06 MB
Adobe PDF
680d62c2c113698afb7d1aaf4481082a