The additive manufacturing (AM) of the gamma' precipitation strengthened Ni-base superalloys still remains a challenge due to their susceptibility to micro-cracking. Post-processing, such as HIPing, has been shown to heal the micro-cracks but it remains desirable to prevent the micro-cracking from even occurring. Numerous studies highlighting potential mechanisms for micro-cracking exist but few solutions have been demonstrated. The intent of this study was to identify the micro-crack mechanisms and demonstrate how process and alloy modifications can reduce the micro-cracking. The micro-crack surfaces exhibit a dendritic appearance that is indicative of solidification cracking. Additionally, Gleeble experiments, simulating the L-PBF induced Heat Affected Zone (HAZ), were conducted below the y' solvus temperature and reveal the existence of grain boundary liquation, indicative of liquation cracking. Two cracking mechanisms are thus coexisting during Laser Powder Bed Fusion (L-PBF) of CM247LC. Based on experimental evidence, reduction in the solidification interval of CM247LC was investigated as a candidate for micro-crack mitigation and a new alloy was developed. As Hf is found to have a significant influence on the freezing range of the alloy, a new CM247LC without Hf was produced and tested. The study also involved two separate and distinct processing conditions to highlight the importance of melt pool geometry on micro-crack density. Samples fabricated with the Hf-free CM247LC, CM247LC NHf, in combination with optimized processing conditions exhibit a reduction in crack density of 98 %. This study demonstrates the importance of both processing conditions and alloy chemistry on micro-cracking in L-PBF fabricated gamma' hardening Ni-base superalloys.