One of the main drawbacks of anode-supported solid oxide fuel cell technology is the limited capability to withstand reduction and oxidation (“RedOx”) of the Ni phase. This study compares the effect of RedOx cycles on curvature and strength of half-cells, composed of a Ni-YSZ support, a Ni- YSZ anode and an 8YSZ electrolyte. Five different treatments were studied: (i) reduction at 600°C, (ii) reduction at 1000°C, (iii) 1 RedOx cycle at 750°C, (iv) 5 RedOx cycles at 750°C and (v) 5 RedOx cycles at 600°C. The strength was measured by the ball-on-ring method, where it is calculated analytically from the force. In this calculation the thermal stresses have been estimated from the curvature of the half-cell. For each treatment, more than 30 samples were tested. About 20 ball-on-ring samples were laser cut from one original 12x12 cm2 half-cell. Curvature and porosity were measured for each sample before and after RedOx treatments. The first observations show that increasing the reduction temperature enhance strength but does not influence the curvature, whereas 1 RedOx cycle at 750°C increases the curvature without changing the strength. Consecutive RedOx cycles seem to decrease anode-supported cell strength, but this is coupled to lower porosity of the sample.