Balestra, SimoneCostagliola, GianlucaPegoraro, AmedeoPicollo, FedericoMolinari, Jean-FrançoisPugno, NicolaVittone, EttoreBosia, FedericoSin, Agusti2022-01-272022-01-272022-01-272022-03-0110.1115/1.4052777https://infoscience.epfl.ch/handle/20.500.14299/1847602110.11838v1We describe benchmark experiments to evaluate the frictional properties of laser patterned low-density polyethylene as a function of sliding velocity, normal force, and humidity. The pattern is a square lattice of square cavities with sub-mm spacing. We find that dynamic friction decreases compared to non- patterned surfaces, since stress concentrations lead to early detachment, and that stick-slip behavior is also affected. Friction increases with humidity, and the onset of stick-slip events occurs in the high humidity regime. Experimental results are compared with numerical simulations of a simplified 2D spring-block model. A good qualitative agreement can be obtained by introducing a deviation from the linear behavior of the Amontons-Coulomb law with the load due to a saturation in the effective contact area with pressure. This also leads to the improvement of the quantitative results of the spring-block model by reducing the discrepancy with the experimental results, indicating the robustness of the adopted simplified approach, which could be adopted to design patterned surfaces with controlled friction properties.Contact mechanicsFrictionInterfaceMicro-tribologyStick-slipSurface roughness and asperitiesTribological systemstext::journal::journal article::research article