Numerically-based method for fracture characterization of Mode I-dominated two-dimensional delamination in FRP laminates

A new numerically-based method suitable for determining the total strain energy release rate (SERA) involved in two-dimensional (2D) Mode I-dominated delamination under opening loads in FRP laminates is presented. The method is based on the mutual dependence of the load vs opening displacement curves slope exhibited after the full development of the fracture process zone (FPZ) and the total SERA involved in the delamination process. The equation relating these parameters is derived from three-dimensional finite element analyses performed using simple linear-softening cohesive zone models. Considering that the load-displacement curve reflects the overall fracture behavior, the above-mentioned slope correlates with the mean total SERA required to propagate the total 2D crack, independently of any local total SERR's variation along the crack front. Thus, the same mean cohesive zone model is used in all directions. By substituting the corresponding experimental slope of the load-displacement curves in the derived equation the total SERA is obtained. The method was validated using the experimental results from three types of GFRP/epoxy laminates with different fiber architectures. The measurement of the crack front is not required and the method is valid for any fiber architecture, crack shape and boundary conditions in Mode I-dominated and opening loading cases.


Publié dans:
Composite Structures, 214, 143-152
Année
Apr 15 2019
Publisher:
Oxford, ELSEVIER SCI LTD
ISSN:
0263-8223
1879-1085
Mots-clefs:
Laboratoires:




 Notice créée le 2019-06-18, modifiée le 2019-06-25


Évaluer ce document:

Rate this document:
1
2
3
 
(Pas encore évalué)