Non-Isolated DC-DC Converters for High Power Appli-cations - Control of the Capacitive Voltage Divider

A non-isolated DC-DC converter is presented, based on the current diverter principle. The converter is foreseen for large power electronic applications where normally the converters are fed from DC supplies at a typical voltage level of around one or two kV. In some specific applications, a primary voltage step-down stage would be used, allowing the adaptation of the voltage of the normal system to a higher DC supply. The Multistage Stacked Boost Architecture MSBA allows a conversion from or to voltage levels higher than the blocking capability of the used semiconductor devices. The paper will describe the control strategy used for the voltage balance of the DC active capacitive divider stage.


Presented at:
PCIM 2014 : International Exhibition and Conference for Power Electronics, Intelligent Motion, Renewable Energy and Energy Management, Nuremberg, Germany, 20-22 May 2014
Year:
2014
ISBN:
978-3-8007-3603-4
Keywords:
Laboratories:


Note: The status of this file is: EPFL only


 Record created 2014-05-23, last modified 2018-09-13

n/a:
Download fulltext
PDF

Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)