Piezoresistive cantilevers in a commercial CMOS technology for intermolecular force detection

We report the development of piezoresistive cantilevers for intermolecular force detection in biochemical sensing, by using a commercial CMOS technology. The detection of the small forces involved in molecular recognition requires cantilevers with a small spring constant and high force sensitivity. We have fabricated polycrystalline silicon cantilevers by using the two polysilicon layers of a commercial CMOS process with minimum design rule widths. The cantilevers have been released by post-process micromachining. The upper polysilicon layer has been used as a piezoresistor. CMOS amplifying circuits have been integrated on-chip with the cantilever structures. The cantilevers have small spring constants ranging from 1.5 to 12 mN/m. The complete system has been successfully tested by applying a known transverse displacement with an AFM tip. A force sensitivity of 8 mu V/pN and resolution of 50 pN has been obtained. This high resolution is obtained with CMOS polysilicon, which has a relatively low piezoresistive coefficient, but this is compensated by the integration of signal-processing circuitry. (c) 2006 Elsevier B.V. All rights reserved.


Published in:
31st International Conference on Micro- and Nano- Engineering (MNE), 83, 4-9, 1302-1305
Presented at:
31st International Conference on Micro- and Nano- Engineering (MNE), Vienna, Austria, 2005
Year:
2005
ISSN:
0167-9317
Keywords:
Note:
Bausells, J CSIC, IMB, Ctr Nacl Microelect, Campus UAB, Barcelona 08193, Spain CSIC, IMB, Ctr Nacl Microelect, Barcelona 08193, Spain ETH, Phys Elect Lab, CH-8093 Zurich, Switzerland, 043EG, Times Cited:0, Cited References Count:17
Laboratories:




 Record created 2013-08-06, last modified 2018-03-17


Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)