Baseline System Design And Prototyping For The Iter High-Frequency Magnetic Diagnostics Set

This paper reports the mechanical and electrical tests performed for the prototyping of the ITER high-frequency magnetic sensor and the analysis of the measurement performance of this diagnostic. The current design for the sensor is not suitable for manufacturing for ITER due to the high likelihood of breakages of the un-guided tungsten wire during the winding. A number of alternative designs and manufacturing processes have been investigated, with the Low Temperature Co-fired Ceramic technology giving the best results. The measurement performance of the baseline system design for the high-frequency magnetic diagnostic cannot meet the intended ITER requirements due to its intrinsic spatial periodicities.


Published in:
2009 23Rd Ieee/Npss Symposium On Fusion Engineering, 221-224
Presented at:
23rd IEEE/NPSS Symposium on Fusion Engineering, San Diego, CA, May 31-Jun 05, 2009
Year:
2009
Publisher:
Ieee Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa
ISBN:
978-1-4244-2635-5
Keywords:
Laboratories:
SPC
CRPP




 Record created 2012-01-12, last modified 2018-09-13


Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)