Gamma rays in nuclear reactors, arising either from nuclear reactions or decay processes, significantly contribute to the heating and dose of the reactor components. Zero power research reactors offer the possibility to measure gamma rays in a purely neutronic environment, allowing for validation experiments of dose estimates, computed spectra, and prompt to delayed gamma ratios. The resulting data can contribute to models, code validation and photo atomic/nuclear data evaluation. To date, most experiments have relied on flux measurements using TLDs, ionization chambers, or spectrometers set in low flux areas. The CROCUS reactor allows for flexible detector placement in and around the core, and has recently been outfitted with gamma detection capabilities to fulfill the need for in-core gamma spectroscopy, as opposed to flux. In this paper we report on the experiments and accompanying simulations of gamma spectrum measurements inside a zero power reactor core, CROCUS. It is a two-zone, uranium-fueled light water moderated facility operated by the Laboratory for Reactor Physics and Systems Behaviour (LRS) at the Swiss Federal Institute of Technology Lausanne (EPFL). Herein we also introduce, in detail, the new LEAF system: A Large Energy-resolving detection Array for Fission gammas. It consists of an array of four detectors - two large circle divide 127x254mm Bismuth Germanate (BGO) and two smaller circle divide 12x50mm Cerium Bromide (CeBr3) scintillators. We describe the calibration and characterization of LEAF followed by first in-core measurements of gamma ray spectra in a zero power reactor at different sub-critical and critical states, and different locations. The spectra are then compared to code results, namely MCNP6.2 pulse height tallies. We were able to distinguish prompt processes and delayed peaks from decay databases. We present thus experimental data from hitherto inaccessible core regions. We provide the data as validation means for codes that attempt to model these processes for energies up to 10MeV. We finally draw conclusions and discuss the future uses of LEAF. The results indicate the possibility of isotope tracking and burn-up validation.