Reinforcement detailing rules describe the shape, geometrical dimensions, and amount of steel to be placed in reinforced concrete structures. They allow for simple and fast designs, account for several effects neglected in the design, ensure a satisfactory behaviour under serviceability conditions, a sufficient robustness, and an adequate behaviour in case of unexpected actions. Most detailing rules provided in codes have not been updated to correspond to current manufacturing processes, material performances and scientific knowledge. They are often based on "rules of good practice" which, while satisfactory, lack a sound scientific basis and may not be needed. This is one reason why detailing rules may differ amongst countries and design codes. Some of these rules are overly conservative, in particular when evaluating existing structures, while others may neglect significant effects. Even though these rules play a major role in the economy and safety of concrete structures, little research has been performed in this domain. Several detailing rules have been identified as needing additional investigations to verify their adequacy to current practical needs and recent technological evolutions. This thesis presents a research programme on three main detailing rules: bend detailing and required mandrel diameter, anchorage of shear reinforcement with bends and hooks and minimum amount of shear reinforcement. This research aims at developing mechanical models, simplified formulas and detailing provisions, on the basis of experimental results. These were obtained using state-of-the-art measurement techniques such as Digital Image Correlation or Fibre-Optic Measurements. Bends and hooks of reinforcing bars are usually obtained by plastic bending of the bars against mandrels. Codes specify minimum mandrel diameters to avoid splitting or spalling failures that may limit the resistance of the detail. The thesis includes a research programme on the detailing of bends and the required mandrel diameter to avoid concrete failures leading to spalling of the concrete cover. A mechanical model for the design of bent reinforcement was developed. A simplifying standard bending procedure is proposed, in which details formerly requiring various bend diameters can be obtained by using a single mandrel, allowing for faster automated manufacturing of bent reinforcement. Bends and hooks at the end of the bars are efficient solutions for the anchorage of reinforcement. However, these details are relatively sensitive to the cracking state of the surrounding concrete. For shear reinforcement, spalling failure of the concrete cover for bars close to the concrete surface can occur. The thesis includes an investigation on the mechanical response and performance of bend and hook anchorages. A mechanical model and practical considerations on the activation of shear reinforcement in beams are presented. The required minimum amount of shear reinforcement in beams and slabs has been discussed for decades. It is crucial to ensure economic and safe new structures and to accurately assess existing ones. The investigation shows that the shear behaviour is strongly dependent on the amount and the post-yield response of the shear reinforcement (ductility class). For all investigated detailing rules, the implementation of these findings into codes is discussed, highlighting the consistency of the recent changes, particularly with the new generation of Eurocode 2.